Planet Library Issue.

[WarpRat]

Hello everyone.

Hey today I was probing around and scouting systems.After nothing but smooth sailing I went to the Planet Library to check on a few things.As soon as I proceeded to probe some more I noticed the probe and my commands were hanging up (lag like). The probe would hang over the STAR it was about to enter then just stick for 5 or more seconds then enter the star system. My commands started backing up. This continued until I went to menus and logged off. All was fine when I came back and continued to probe until I used the Planet Library again. The same issues came back immediately but this time even worse. I received the "An Error has happened" message. I logged out and everything cleared up again. Have not used the Planet Library since. Outside of that everything looks and runs great.

Thanks

[Cossid]

Thanks for reporting this. I have seen a few issues pop up from the Planetary Library. I have the first attempted fix ready to go for the next release, but it is something that has been difficult to reproduce locally. Yours is actually a new one, I'll look into it.

[WarpRat]

Hello Sir

Not sure if it was the updates that helped fix the problem I was having or if it was on my end but it did seem to help a bit. I have the same problems but not nearly as bad. I still get the same "hang time" "lag" after opening the Library whenever i use my probe but the "lag" problem is about cut in half. Keep up the nice work.

Thanks Again!

[Cossid]

Well, I initially only attempted to solve the error that would pop up when you and your probe entered a system at the same time.

The next release should be slightly better performance-wise, but it is difficult for me to effectively test, as my dev machine is just too fast to really see where slower systems would struggle. I'd appreciate additional speed feedback after 0.7.0.8 is released (next couple days most likely).